Elements and Performance Criteria
- Inspect single layer printed circuit cards and associated components
- Relevant maintenance documentation, including component defect reports where applicable, is interpreted and matched by part and serial number
- Preparation of work area and circuit card assemblies is appropriate to allow for effective detailed inspection of all substrate, circuit tracks, edge connectors and attached components, taking into account any static discharge procedures
- Circuit card assemblies are visually or physically inspected for physical integrity of substrate, circuit tracks, edge connectors and attached components
- Modification status is established to assist in determining repair requirements
- Defects are correctly identified and reported
- Test single layer printed circuit cards and associated components
- Circuit card assemblies are correctly prepared and connected to the appropriate test facility in accordance with approved procedures, or circuit card assemblies are correctly prepared and connected in situ to allow required test procedures to be performed
- Circuit card assemblies are functionally tested in accordance with normal trade practice and approved maintenance documentation for evidence of serviceability or malfunction
- Circuit card assemblies, attached hardware and electronic components are electronically and/or physically adjusted/aligned in accordance with maintenance manuals or other prescribed procedures
- Troubleshoot single layer printed circuit cards and associated components
- Maintenance documentation, physical inspection and test results are used, where applicable, to assist in fault determination
- Maintenance manual fault diagnosis guides, logical processes and test equipment are used appropriately to ensure efficient and accurate troubleshooting
- Component faults are located and the causes of the faults are clearly identified and recorded in maintenance documentation, where required
- Rectification requirements are determined
- Dismantle single layer printed circuit cards and associated components
- Conformal/protective coatings are removed from the circuit card assembly to the extent required to effect necessary repairs and in accordance with maintenance manuals, industry or enterprise standards as applicable
- Appropriate OHS precautions are observed at all times during maintenance procedure
- Circuit card assembly is dismantled to the extent necessary to allow repair of all identified faults
- Parts for processing are correctly tagged and despatched
- Parts for retention and re-fitment are correctly packaged and stored in accordance with approved procedures to avoid physical and electrostatic damage
- Parts for disposal are correctly packaged and processed to accord with statutory requirements pertaining to dangerous goods
- Assemble single layer printed circuit cards and associated components
- Parts removed for access, and replacement parts, are collected ensuring appropriate modification status, component tolerances and assembly configuration is maintained
- Printed circuit card and associated components are assembled in accordance with maintenance manuals, and all electrical joints meet the approved standard of the equipment manufacturer, or industry standard, as appropriate
- Circuit substrate material, circuit tracks, edge connectors and through-hole eyelets are reworked, as necessary, to restore printed circuit card to a serviceable condition
- Rework techniques are in accordance with industry approval procedures and relevant OHS requirements are observed